Drawn from openFDA device enforcement reports. Filter by severity, status, state, year, or manufacturer.
Showing 733–744 of 2,908 recalls
Product service credentials used by some BD technical support teams to access certain BD products were accessed by an unauthorized actor.…
Product service credentials used by some BD technical support teams to access certain BD products were accessed by an unauthorized actor.…
Product service credentials used by some BD technical support teams to access certain BD products were accessed by an unauthorized actor.…
Product service credentials used by some BD technical support teams to access certain BD products were accessed by an unauthorized actor.…
Product service credentials used by some BD technical support teams to access certain BD products were accessed by an unauthorized actor.…
Medline has identified a limited quantity of saline IV flush syringes that may not meet the required concentration of sodium chloride.
Affected oral/axillary probes were inadvertently programmed with the rectal probe configuration. Affected probes will potentially display a lower temperature than the true value, which may lead to a delay in managing fev…
A software defect in versions 7.9.0.1 and 7.10.1 of the pump software for Tandem t:slim X2 and version 7.9.0.1 of the Tandem Mobi pump with Control-IQ+ technology that are paired with a G7 sensor may result in an unexpec…
If a user incorrectly places the Acquisition Module into the Acquisition Module Holder, it can result in excessive bending and wear of the Acquisition Trunk Cable. This is visible as a damaged sheath or exposed wires.…
Instructions for use for a foot plating system is being updated to remove the second option of requirements for sterilization which was 3 minutes exposure time at 134-137-degrees C (273-279-degrees F) and 40mBar for 5-10…
Although the etched length on the screw is correct, the length marked on the external packaging is incorrect. Specifically, 42mm screws were packaged and labeled as 46mm, while 46mm screws were packaged and labeled as 42…
Although the etched length on the screw is correct, the length marked on the external packaging is incorrect. Specifically, 42mm screws were packaged and labeled as 46mm, while 46mm screws were packaged and labeled as 42…